who sells spring perches online

[rockwerks]

...anyone? need perches for a dana 44 comanche for spring over

 

[Eagle]

Can't remember, but I know I've seen them. Try:

Summit Racing
Mopar Performance Catalog
Rubicon Express
Mountain Off-Road Engineering (M.O.R.E.)

 

[Eagle]

Mopar Performance, part number P4120074

I assume this part number is for one side. Says it is for all axles with 3" tubes, including the 8-1/4". Dunno if the Dana 44 is 3", but I'm sure a bit of grinding and/or welding would adapt them if not.

 

[cbremer]

FWIW, the XJ dana 44 has 2.75" diameter axle tubes.

 

[gixer]

Try your local napa or Rustys off road.

 

[woody]

I have bought these from Rubicon and more recently from Mountain Off Road.

The MORE ones are heavy duty, and have 3 stud holes to adjust your WB forward or back 1.5" or so if ya need to.

For a 44 the PN is 98105, they are $45 a pair and $12.42 shipping from CO to NC, be cheaper to AZ

Rubicon part # is RE1930 IIRC (2.5x2.5 anti-wrap) and were a bit less $ but weren't as beefy and only had one location hole These worked well on my 44 SOA while it was under the MJ

This all reminds me...my spooled & 4.56:1 SOA MJ 44 ax is maybe done over to SOA XJ? Have to call the fab shop this morn... Shix my Jeep is loaded up too :me cry: Ah well...looking forward to swapping out though. Maybe next week.

 

[XJJPR]

RE
MORE
Currie

mark
orgs mfg

 

[rockwerks]

Thanks Guys...I actually just stopped into american spring here in Flagstaff he had heavy set with welded end plates and made me up 5/8" u bolts......for a real good price.....40.00 for it all....I always forget about Scott over there.

 

[dbxj]

Mopar Performance, part number P4120074

I assume this part number is for one side. Says it is for all axles with 3" tubes, including the 8-1/4". Dunno if the Dana 44 is 3", but I'm sure a bit of grinding and/or welding would adapt them if not.

FWIW, the XJ dana 44 has 2.75" diameter axle tubes.

So the MOPAR perches won't work on the 44?

db

 

[rsalemi]

Im putting a set on a D44 today. Welding can fill small gaps - most of those perches sold are advertised to fit fords, Jeeps, etc.

 

[Tom_T&Js_Offroad]

[email protected]
Have your spring width and tube diameter. Thety are like $17.00 a pair.

 

[Digger87xj]

So the MOPAR perches won't work on the 44?

db

YES, .... they will.... been there done that,.. AND they are like 12 bucks

 

[Fergie]

Thanks Guys...I actually just stopped into american spring here in Flagstaff he had heavy set with welded end plates and made me up 5/8" u bolts......for a real good price.....40.00 for it all....I always forget about Scott over there.

Yup, the Dana bros always have what ya need, for a semi decent price. Gotta go there today to get some u-bolts and center pins.

Fergie

 

[dbxj]

Thanks for the replies.