- Location
- Torrance, CA
I need a custom downpipe for the red Jeep. It's going from the Borla header to the catco, the header's output is 2.25" and I have the flange for the cat end in both 2.25" and 2.50" so that's no issue. It's a pretty simple pipe consisting of two roughly 90 degree bends, I'd prefer mandrel bent tube but don't mind using off the shelf elbows welded to sections of straight pipe. At the header end I'd like to use one of those sleeve style clamps to minimize it's footprint to keep the yoke / driveshaft out of the exhaust.
Location is pretty important here as the Jeep doesn't have a downpipe right now so I'd either need to drive it if it's close or have it towed.
So..... Anybody here up to the job?
Location is pretty important here as the Jeep doesn't have a downpipe right now so I'd either need to drive it if it's close or have it towed.
So..... Anybody here up to the job?