jolly_rogger
NAXJA Forum User
- Location
- canada
as some of you know from other posts i had some trouble from time to time with long starts....hot or cold. Awhile ago it started jerking a few times and died in an intersection. it jerked as if there wasn't any gas real quick and died. no mater what it would not start.
Here are both my old posts.
http://www.naxja.org/forum/showthread.php?t=944427
http://www.naxja.org/forum/showthread.php?t=947592
so far this is what i have done and still won't start.
I checked the presure release valve at the front of the fuel rail and gas does spray out.
Air filter is good
New plugs
New wires
New Cap and Rotor
Replaced the coil with one i know forsure is good.
New Crank sensor. pretty sure i can't screw that but if there is any other tricks for re-intallation please let me know. Is there anyway to screw it up...lol ?
Good compresion.
Motor turns over.
Things that i know still need to be fixed but i don't think can cause it to not start are:
Neg ground wire from bat need to be replaced. i hooked up a temp ground by using jumper cables and conecting them to the motor. still didn't start.
Only thing i can think of is that i found a broken part on the drivers side of the motor just above where the oil pan starts to slope down. I thought this might be the oil pump but I am not sure as I can not find my manual at the moment.
Any Ideas ? The motor does crank over just won't start and I have had this thing sitting in my driveway for a few months now and i am starting to get verry fustrated with it.
Thanks
:skull1:
Here are both my old posts.
http://www.naxja.org/forum/showthread.php?t=944427
http://www.naxja.org/forum/showthread.php?t=947592
so far this is what i have done and still won't start.
I checked the presure release valve at the front of the fuel rail and gas does spray out.
Air filter is good
New plugs
New wires
New Cap and Rotor
Replaced the coil with one i know forsure is good.
New Crank sensor. pretty sure i can't screw that but if there is any other tricks for re-intallation please let me know. Is there anyway to screw it up...lol ?
Good compresion.
Motor turns over.
Things that i know still need to be fixed but i don't think can cause it to not start are:
Neg ground wire from bat need to be replaced. i hooked up a temp ground by using jumper cables and conecting them to the motor. still didn't start.
Only thing i can think of is that i found a broken part on the drivers side of the motor just above where the oil pan starts to slope down. I thought this might be the oil pump but I am not sure as I can not find my manual at the moment.
Any Ideas ? The motor does crank over just won't start and I have had this thing sitting in my driveway for a few months now and i am starting to get verry fustrated with it.
Thanks
:skull1: