xj-grin
NAXJA Member #1096
- Location
- Colorado Springs, Colorado
What size gear to I need to correct my speedo w/33's and 4.10's on a 4.0 w/ the AX-15? Where can I pick one up? TIA
speedo gear
- Thread starter xj-grin
- Start date
cbremer
NAXJA Member #393
used this site with good results: http://www.jeeptech.com/javaAps/Speedo.html
You can get the speedo gears at the Jeep dealer parts department, or www.parts.com my gear cost about $8
You can get the speedo gears at the Jeep dealer parts department, or www.parts.com my gear cost about $8
xj-grin
NAXJA Member #1096
- Location
- Colorado Springs, Colorado
Thanks for the info, but my original gear is shredded, so I can't apply the equation. Do any of you guys have some experience to share as far as which gear to use for 4.10 and 33's w/an AX-15?
TIA
TIA
satan
NAXJA Forum User
- Location
- Lakewood, CO USA
Chart here:
http://go.jeep-xj.info/HowtoSpeedoGears.htm
says 33-tooth....
... generally if you have a counter-guy look-up the gear you need for your "stock" application, the last 2-digits are the tooth count -- similarly if you want a 33 tooth - you can have the guy look-up the OEM number then substitute the "33" in to get the gorrect gear....
http://go.jeep-xj.info/HowtoSpeedoGears.htm
says 33-tooth....
... generally if you have a counter-guy look-up the gear you need for your "stock" application, the last 2-digits are the tooth count -- similarly if you want a 33 tooth - you can have the guy look-up the OEM number then substitute the "33" in to get the gorrect gear....
xj-grin
NAXJA Member #1096
- Location
- Colorado Springs, Colorado
Thanks satan (not something I say al that often...). just the info I needed!
