Reader's Rig's

[Jump This]

too much skinny pedal

I hear you were draggin' your balls too!

 

[Jump This]

The most recent picture of mine....

 

[GrimmJeeper]

I hear you were draggin' your balls too!

yep they snapped right there, i dragged em by the wires up the hill, and then they went flying threw the air!

 

[CanMan]

Just a update of sorts.

'91 Laredo
4.0
AX15
231 w/ PORC SYE
Aussie locked, 4.56 geared D30
Miller locked, 4.56 geared 8.25
Lengthened front shaft in rear
RuffStuff diff covers
Custom OTK steering, 1.25" OD, 5/16" wall DOM, 3/4" QA-1 rod ends
Custom TB, Modified stock bracket on 'frame', custom on axle, 1.25" OD, 1/4" wall DOM, 7/8" QA-1 rod ends
Skyjacker(?) 3" front springs, 2" RE spacer, Rev Den/Gi John shocks
RE fixed upper and lower CA's
Bastard pack rear w/ TnT Boomerang shackles, Rancho RS5000 shocks, relocated shock mounts on axle
33x12.50x15 Bias Ply TSL's on 15x8, 3.75" BS Cragar wheels.
JCR front bumper
Drawtite rear hitch
Custom TC skid
Flowmaster
Busted up TJ flares
Custom rock lights
Cheap daylighters
Lots of body damage

 

[Prerunner]

Finally got to take it out wheeling and see how it works.

Flexed more then i expected, Bump stop spacers and some flairs will be needed

Was the first lucky one in what became a bottomless mud hole

My Girlfriend had lots of fun on the rocks

One goey Tank Trap

Had to trim the ends off the unfinished bumper, they wanted to eat my 33's

 

[Bult4mud]

TORE IT UP AT GRAND MANS HUH

looks like a solid rig man how much lift?>

 

[crawlerxj]

here's mine

Just received my new set of rubber .... IROKS 42" on 17"


Here what the xj was looking on 39½ iroks

here's some parts just waiting to be installed

4 firestone 16" travel airbag with independant controllers
Crawler box 231/300 with 32 splines outputs front and rear
Rear 14 bolts disk conversion with detroit locker
Front gm d60 hi steer full hydro
True triangulated four links front and rear
Vickens vtm42 hydro pump
Brand new 10500 lbs MileMarker hydrolic winch
aluminium 15g fuel cell
Custom 17" beadlock
AWSHIFTING controller
York 210 compressor
Supercharged ( got it but will not be installed this year )

and so much more .............

BYE BYE Buswacker ..... Hello tube fender ..... also tubing almost the entire rear section of the xj.

 

[goodburbon]

here's mine

Just received my new set of rubber .... IROKS 42" on 17"


Here what the xj was looking on 39½ iroks

here's some parts just waiting to be installed

4 firestone 16" travel airbag with independant controllers
Crawler box 231/300 with 32 splines outputs front and rear
Rear 14 bolts disk conversion with detroit locker
Front gm d60 hi steer full hydro
True triangulated four links front and rear
Vickens vtm42 hydro pump
Brand new 10500 lbs MileMarker hydrolic winch
aluminium 15g fuel cell
Custom 17" beadlock
AWSHIFTING controller
York 210 compressor
Supercharged ( got it but will not be installed this year )

and so much more .............

BYE BYE Buswacker ..... Hello tube fender ..... also tubing almost the entire rear section of the xj.

Are those front tires a different size from the rear ones?

 

[crawlerxj]

no they are the sames ... on the picture those tires are my old brand new39½ irok. It's just the way the picture was taken !!!

 

[blue88xj]

Here are some pics of my newest xj. This is how i bought it....'99 Cherokee Sport, 4.0, aw4, np231, 8.25'' in back, and d30 in front, cowl induction hood, RE 4.5", 32'' BFG a/t, ARB bull bar in the front, warn winch, olympic rear tire carrier, spiral flow intake system, jet performance chip, throttle body spacer, upgraded plugs and wires.

Here she is next to a stock xj.

This is the trailhead to "Soldier's pass" in Sedona, AZ.

Getting up on a stump. (I should have discoed for this shot)

Just a driveway shot.

The ARB bull bar is going to be the first thing that gets swapped out. Once it's time for new tires I am going to upgrade to 33's (I can not decide which ones though, so any suggestions would be appreciated). I also plan on adding the Bushwacker cut-out flares. Oh, and rock sliders, and a little bit of rhino lining.

 

[pb_beaker]

Finally got it trail ready and here is a pic of its maiden voyage.

 

[Kendrik]

Here's my jeep after the build-out last weekend. Couldn't have done it without Mr. Goodburbon!

Here's a link to the Picasa Web Album of the before / during / after shots.

3.5" Custom Lift (GB parted it out)
RuffStuff Front and Rear Diff Armor
JCR Level 2 Rails
PowerTrax Rear Locker
Aussie Front Locker (not in yet)
ORFab Front Bumper (wrong part...waiting for winch bumper)
Superwinch EP9000 (waiting to install)
Skyjacker Sway Bar quick disconnects
Skyjacker Nitro Shocks
31x10.5x15 SSR's


Hopefully we'll get out to Barnwell in the next few weeks for it's maiden voyage.

 

[MUDFLAP]

Nice lookin XJ, Did you do a SYE? Any rubbage?

 

[Kendrik]

Nice lookin XJ, Did you do a SYE? Any rubbage?

Thanks! I'm quite happy with it, now!

No SYE, yet. I'll keep an ear out for issues, though. I do get some control arm rub when I turn all the way in either direction, but nothing un-bearable. We haven't flexed it out, yet, though, so no idea if I'll hit the fenders.

 

[Renegade]

Sweet XJ, what kind of rear springs did you use? AAL+Shackle?

 

[goodburbon]

Stock HD replacement from quadratech and teraflex shackles.

 

[imthehink]

3.5" OME, RE

 

[skydizzle]

heres my new wheelin rig. stock but not for long.

 

[XJ Coyote]

Here's my poser shot, hopefully Ill have some wheeling pics up after this weekend

click the pic for a bigger one...computers hate me

 

[jerseyjeep01]

Here's my poser shot, hopefully Ill have some wheeling pics up after this weekend

click the pic for a bigger one...computers hate me

Specs?? I'm building a late model also. Yours looks really good.