Pics from Superlift this weekend.

[SpartyKrunk]

You know what I realized?
You have rims like all the beaners with trucks at my school do.
lmao
:laugh2::roflmao::chef::looney::clap::jester::yap::laugh::laugh3:

 

[uniquexjbannon]

I ordered them on 3/18/2009, and installed them when I received them, they have barely been on there a month or so. They had completely spit out the snap ring and washer, and the bushing in the flex joint was badly wallowed out. My axle would roll forward and backward about an inch or two whenever I started or stopped moving. I took out the uppers, and pressed the bushing back in with the washer, and put the snap ring back in, but they are still really sloppy and loose. I still get some axle roll even with them back in. Worst part about it, is that the ruined flex joints, have now caused my new "axle end" upper control arm bushings to go. So now I get to deal with the PITA of replacing them again. I am currently messaging back and forth with Jason from RC about it.

I had the same problem with a couple of mine, but they were only the ones that took the most stress on my Y-links. So i replaced them with these
This is what I had:

Replaced it with chromoly heim

You can see it on the axle..its beefy!

 

[x2elite]

Hmmmmmmmmm........ nice..... how much???

 

[uniquexjbannon]

They were about $75 a piece. There was prob some shipping added to it to, but it was n with some other stuff to, so I don't know how much. They weigh about 5lbs a piece

 

[x2elite]

If the threads were the same as the joints from RC I think it would be worth it to replace the joints with those.

 

[uniquexjbannon]

Mine were! Brought the flex joints frrom currie, and those heims from my buddy (he sells them). Took 30min. Let me know if I can help any

 

[uniquexjbannon]

The thread pitch is 1 1/4 x 12. The shank is for 1 1/4" pipe and accepts 1" bolt, unless you have high mis-allignment spacers then bolt goes down to a 3/4"