gimike812
NAXJA Forum User
- Location
- Tucson, AZ
Drive train parts
Complete running 4.0l from 87-89 cherokee with ax-15 5 speed trans. Wanting to sell as a complete assembly. Odometer shows 280k miles but this thing runs really smooth. Better than my other one with 200k miles. Its been taken care of or rebuilt I am not sure. You get Fan to trans, throttle body to oil pan, wiring harness, computer, all emissions stuff, all asserories minus a/c stuff, exhaust cut 5inch past cat so you get everything to install in to your project. Asking $500 Make offer you help pull it all even cheaper.
video of it running http://www.youtube.com/watch?v=lJiHuQh0utA
Interior parts
Tan interior parts. All most all plastic panels for a 87-89 four door are there let me know what you need.
Glove box Door $5
Insterment cluster $10
The dash Cubbie box under the Dash $5
Clutch, Break and Thottle peddel assy $20
Doors
Driver and passenger side rear Glass $25 each
Four door rear doors Black exterior Tan interior with power windows and locks. good glass Driver side and passenger $20 each
Passenger side front door, power window, power locks, trashed interior panel all sheetmetal good, glass good. $15
Drivers side door no interior panel, power lock and windows, glass good, the lock was busted out so the metal around it is rusted and bent up. $10
Exterior
Stock front bumber off a 90 xj W/ Chrome brush guard with winch plate, front reciver, and 2 lights. $100
Have a 87-88 4 door body Will cut any piece of sheetmetal off if you need any piece let me know.
Differential parts
Chrysler 8.25 LSD 29spline trac-lok factory replacement Brand new in the Box $300
8.25 ring and Pinnion gears Brand new in the Box 4.10 gears $125
8.25 Master install kit brand new all bearings and seals to rebuild the axle $50
Will take $425 for all the 8.25 parts.
May deliver in tucson and possibly phoenix metro area.
Willing to trade parts for any thing I am looking for.
Locker for ford 8.8 or D30.
The D30 long shaft to convert my D30 disco axle.
4.10 gears w/ carrier for a D30.
231 Tcase with sye
Off-road or rock lights.
Wench and other recovery gear.
Hi-lift jack
On board air or Power tank
A shop air compressor no less than 60Gal
Let me know What you have Make me an offer I can only say yes or no. There not doing me any good.
PM me or Call me at 520-977-410Three If I dont answer leave a message I will call back.
Complete running 4.0l from 87-89 cherokee with ax-15 5 speed trans. Wanting to sell as a complete assembly. Odometer shows 280k miles but this thing runs really smooth. Better than my other one with 200k miles. Its been taken care of or rebuilt I am not sure. You get Fan to trans, throttle body to oil pan, wiring harness, computer, all emissions stuff, all asserories minus a/c stuff, exhaust cut 5inch past cat so you get everything to install in to your project. Asking $500 Make offer you help pull it all even cheaper.
video of it running http://www.youtube.com/watch?v=lJiHuQh0utA
Interior parts
Tan interior parts. All most all plastic panels for a 87-89 four door are there let me know what you need.
Glove box Door $5
Insterment cluster $10
The dash Cubbie box under the Dash $5
Clutch, Break and Thottle peddel assy $20
Doors
Driver and passenger side rear Glass $25 each
Four door rear doors Black exterior Tan interior with power windows and locks. good glass Driver side and passenger $20 each
Passenger side front door, power window, power locks, trashed interior panel all sheetmetal good, glass good. $15
Drivers side door no interior panel, power lock and windows, glass good, the lock was busted out so the metal around it is rusted and bent up. $10
Exterior
Stock front bumber off a 90 xj W/ Chrome brush guard with winch plate, front reciver, and 2 lights. $100



Have a 87-88 4 door body Will cut any piece of sheetmetal off if you need any piece let me know.
Differential parts
Chrysler 8.25 LSD 29spline trac-lok factory replacement Brand new in the Box $300
8.25 ring and Pinnion gears Brand new in the Box 4.10 gears $125
8.25 Master install kit brand new all bearings and seals to rebuild the axle $50
Will take $425 for all the 8.25 parts.
May deliver in tucson and possibly phoenix metro area.
Willing to trade parts for any thing I am looking for.
Locker for ford 8.8 or D30.
The D30 long shaft to convert my D30 disco axle.
4.10 gears w/ carrier for a D30.
231 Tcase with sye
Off-road or rock lights.
Wench and other recovery gear.
Hi-lift jack
On board air or Power tank
A shop air compressor no less than 60Gal
Let me know What you have Make me an offer I can only say yes or no. There not doing me any good.
PM me or Call me at 520-977-410Three If I dont answer leave a message I will call back.