how to push tire back some

The front is getting pushed out...
The rear was a concern but after reading everyones posts..i shouldn't have to worry.

Thanks All

Mark
 
Mine stuff so far up in the fender well that the top of the tire hits the top center of the fender well. Mine are also cut all the way up to the spot welds.

...I no longer have spot welds, or pinch seam.
if you take a marker, trace around a factory mounted flair, and cut that line... that is how far I have trimmed :)
(More commonly known as a stump cut)

I have a picture of a 38 TSL clearing with 2" all the way around, at ride hight, when I was only lifted 3"... jjst don't have that pic on my phone or I'd show ya...
 
...I no longer have spot welds, or pinch seam.
if you take a marker, trace around a factory mounted flair, and cut that line... that is how far I have trimmed :)
(More commonly known as a stump cut)

I have a picture of a 38 TSL clearing with 2" all the way around, at ride hight, when I was only lifted 3"... jjst don't have that pic on my phone or I'd show ya...


What'd you do to fill the gap?
 
Comp cut, gas tank relocation, flip leaves for ~5" stretch and run as big a tire as you want.
 
Yah I know we're not talking wranglers but if you comp cut the rear section then you can stretch the wheelbase to whatever you want and not have to worry about rubbing front or back of the wheel well.
 
Back
Top