silvrzuki77
NAXJA Forum User
- Location
- VEGAS
Hey been lurking around here while collecting parts for my XJ. This is my 3rd xj and this one I got for free from the inlaws after their son left for the marines. Its a 2001with about 75000 on it. Had several electrical problems that was from bad wiring from the amp he had installed. Lots of little issues. Replaced all the seats from a grand cherokee and installed the over head trip computer. This is going to be my DD and Over built camping rig. Already have a crawler so trying to keep body damage to min. Here is when I got it.
part of electrical problem ( dont ask I dont know)
85 waggy axle now loaded with all new hardware 4.56 and ez locker
Before and after my $5 pic apart hubs to switch out the full time hubs
Rear 44 from isuzu rodeo with 4.56 and truetrac
TNT truss cut set 5 degrees
All welded on
soo purrty
For lift I did a mix and match of different parts
RC long arm kit and trac bar, rustys 4 coils with 3/4 puck and grand cherokee lower isolator, and s-10 bastard pack with 2" shackles.
I did TNT stiffners but no pics which threw alot of stuff off.
Out with the old
Plasma cut the brackets off
After bolting the rear crossmember on with the stiffners the side keeper brackets where off also the front holes on the frame were not threaded so I had to tap it my self.
Solution was to weld plate on to give more surface area
Long arms installed
part of electrical problem ( dont ask I dont know)
85 waggy axle now loaded with all new hardware 4.56 and ez locker
Before and after my $5 pic apart hubs to switch out the full time hubs
Rear 44 from isuzu rodeo with 4.56 and truetrac
TNT truss cut set 5 degrees
All welded on
soo purrty
For lift I did a mix and match of different parts
RC long arm kit and trac bar, rustys 4 coils with 3/4 puck and grand cherokee lower isolator, and s-10 bastard pack with 2" shackles.
I did TNT stiffners but no pics which threw alot of stuff off.
Out with the old
Plasma cut the brackets off
After bolting the rear crossmember on with the stiffners the side keeper brackets where off also the front holes on the frame were not threaded so I had to tap it my self.
Solution was to weld plate on to give more surface area
Long arms installed