• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Floor pans

Quadratec has them under Body and Frame Parts.
 
I used seam sealer (although I'm sure roof tar works just the same) but the brush on 3M stuff is like 30 bucks for a big can and its identical to the OEM stuff. You may be better off either cutting one out of another jeep or getting some steel and making your own pan.
 
Best and most complete one I have found yet:
http://www.discountjeepparts.com/product_info.php/products_id/28548

However I just picked up 2x sheets of 4'x8' 18 gauge steel. Together they cost me a total of $110 or so and one sheet should be enough to make all of the floor I need (if I don't waste any... which is not likely :laugh:)

Are you planning to weld it in or what?
 
Yea I seen the whole rear pan for 159.95, its not bad but the shipping of 94 is whats bad, so i think i am just going to get some metal and make my own. i am going to weld it
 
Back
Top