Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
I was giving the numbers so that you could tell me what kind of adjustments to make (i.e. move the carrier .003" closer to the pinion, etc.).
We don't have a housing spreader so I can't guess what the carrier preload is. It takes a couple big hits with a 4 lb deadblow to get the carrier fully seated. The other three issues are addressed in my last post.
I would run that but before you button that up remember that you need to grind a couple of the ring gear teeth down to get the cross pin installed. Or take your ring gear back off to install the pin and then check the pattern again.