ADVNTURR
I worry when rattles stop
- Location
- Cleveland, OH
I am looking for anyone who has done one of these installs because (as usual) mine is going very poorly. Everything went together smoothly from the standpoint of installing it into the carrier. Both my pin gap and my center gap were within spec. I didn't have any problem getting the spacers in or the pins and springs. I now have it back in the axle, new axle shafts in place, everything mocked up to do the "Spin Test" but it doesn't pass. I have the vehicle in 4wd, my vacuum disconnect engaged and I had my wife hold the drivers side wheel back against the drive shaft but I can not spin the passenger side in either direction. Has anyone run into this before. I really don't want to have to pull the entire front axle apart again, I've been working on this for almost 10 hours (replaced seals too) and it is getting frustrating to say the least.
Any thoughts would be greatly appreciated.
Any thoughts would be greatly appreciated.