Cut and folded quarter panels and 7 wire towing harness

[Kejtar]

How should I route it? I did the drivers side cut and fold so tat it leveled it out with the floor from underneath, but now I don't know where to pull the wires for the towing setup through. I can't bring them out to the bottom cause if I land on them I will rip them and short them out. Anyone has any ideas/suggestions?

 

[Safari Ary]

Remi, I brought mine out the bottom, my bumper has 2x4 steel running up to the rear wheel well, so that protects the wires.

Ary

 

[Kejtar]

Remi, I brought mine out the bottom, my bumper has 2x4 steel running up to the rear wheel well, so that protects the wires.

Ary

OK, that is definately something to consider as I will be building my rear bumper over the course of next 2 months
Any other ideas anyone?

 

[RED BULL]

There is a little round rubber "plug" next to the tail light if you have the rear hatch open. I poked a hole in that and ran the wires through there...you can drop them down behind the bumper as well and you only see a short section of the wires when you open the hatch. Might work for ya...

Aaron

 

[Kejtar]

There is a little round rubber "plug" next to the tail light if you have the rear hatch open. I poked a hole in that and ran the wires through there...you can drop them down behind the bumper as well and you only see a short section of the wires when you open the hatch. Might work for ya...

Aaron

Yeah, I have been looking at actually as I found another piece of my tail light and I had it out to glue it up this afternoon. I think that this might be my best bet: for a cleanest install.