partsxj
NAXJA Forum User
- Location
- Freehold, NJ
I am new to this. I have searched the forums for this problem but I have not seen this. I had to replace my trans, the BA10. I also replaced the internal slave cylinder, hose, and master cylinder. I bleed the clutch, it works fine for a while then it's gone. The pedal grabs right off the floor and it is difficult to put into gear. Pumping the cylinder gets it into gear, barely. This is supposed to be my commuter Jeep, but now it sits in the driveway. Should I start over replacing cylinders? Any help would be helpful. I hope I didn't miss the answer for this somewhere on these forums. This Jeep needs to be driven. Thanks.