Build thread: Out of Misery, again...

[Fore Wheeler]

These things fit nice...

 

[Smash Hole]

A lot better than that H brand that we do not speak of

 

[BlckHwk13]

They look great! Way better looking than the H brand

 

[SAMSET]

Man those things really do fit nice

 

[RAM-ROD]

are you gonna spill the beans on what you're replacing it with?

Sure...Hybrid is going on / in our rig......The cage we sold Dan is a great / very safe cage but it is time to go Hybrid being I can see her being on her lid a real possibility now.....


Ram" Just please not on Moab Rim" Rod..........

 

[RAM-ROD]

These things fit nice...

One of the best investments we made for Tara's ride..... Looks great Dan...I see what you did there you waited to get the red rock ground into your carpet then installed.

Ram" Wheeler is a genius" Rod

 

[Fore Wheeler]

Re: Re: Build thread: Out of Misery, again...

They look great! Way better looking than the H brand

Yes! Thanks again Kelly!

Fore 'H, the name we do not speak' Wheeler

 

[kmanxj5050]

What is the "h" word!

K "derka derka" man

 

[XJosh95]

What is the "h" word!

K "derka derka" man

 

[darksidemj]

The jeep looks like it performed great and looked good doing it. I have never seen any rear mats like that before but really dig it. Also I may have missed it but I know there was some debate on the lower control arm skids and that you initially didn't weld them to the axle tube, did you ever end up doing it or no?

 

[Fore Wheeler]

Re: Re: Build thread: Out of Misery, again...

The jeep looks like it performed great and looked good doing it. I have never seen any rear mats like that before but really dig it. Also I may have missed it but I know there was some debate on the lower control arm skids and that you initially didn't weld them to the axle tube, did you ever end up doing it or no?

I did not weld them anymore than in the original pix.

Strangely enough, I didn't tear them from the axle.

 

[kmanxj5050]

You need some of those notch customs flares for this thing!

 

[Fore Wheeler]

Re: Re: Build thread: Out of Misery, again...

You need some of those notch customs flares for this thing!

I was looking at them in Moab. They were at the event, I like them a lot. Problem is they're ~$500. I will buy a rear arb first.

 

[POLAR_JEEP_04]

Those notch flares are sexy!

 

[kmanxj5050]

^^^^^ what he said

 

[Fore Wheeler]

a bit of an update, I haven't done much since Moab, however I have got some rear end noise. Not sure if it's a bearing or gear noise yet. Need to pull the cover.

I will be modifying my sye yoke and cutting my ds down another inch too.

I will also be installing my cage before Winterfest in hopes to not need it, ever.

 

[VAhasnoWAVES]

better to have it and not need it... right?

 

[POLAR_JEEP_04]

Even if it is just a bolt in cage

 

[Smash Hole]

Even if it is just a bolt in cage

Dude this is the bolt in cage of bolt in cages. Nicer than most of the weld in stuff you see.

 

[RedHeep]

Haters gotta hate