Bearing race driver 4" ?

[blondejoncherokee]

Anyone know where to get a bearing race driver for the big race in the bolt hubs? Az and oriellys don't have any that big in their rentals and hf doesn't have anything that big either. It's around 4"

 

[Bryan C.]

Remover or installer? A good brass punch works well on hardened steel bearing races.

 

[blondejoncherokee]

I ended up getting some brass drifts at Napa on north gate and they worked great

went to HF, Home depot, AZ, lowes, sears, 2 ace hardwares, and no one had brass drifts! Not a single person knew what they were even. Napa hub store knew exactly what I was talking about and had them in stock. wasted a lot of time trying to find some.

 

[Bryan C.]

I ended up getting some brass drifts at Napa on north gate and they worked great

went to HF, Home depot, AZ, lowes, sears, 2 ace hardwares, and no one had brass drifts! Not a single person knew what they were even. Napa hub store knew exactly what I was talking about and had them in stock. wasted a lot of time trying to find some.

That's funny, I had the same issue years ago. I was about to just go buy some brass round stock and cut it to length. Even the snap-on, mac, and matco trucks didn't stock them. Had to order one.

 

[blondejoncherokee]

I started getting pissy after like the 6th store when no one knew what they were. I was extremely happy to hear napa say they had like 8 sets in stock.