amp7876
NAXJA Forum User
- Location
- Greenville, IN
Built 98 Jeep Cherokee Limited with leather, pw, pl, auto, ac etc... all in working condition.
4.0L motor, AW4 tranny, NP242 transfer case
Vehicle has appx 110k miles, motor has appx 35K, (original overheated and cracked the head)
Exo Cage made of 1.75" .120" wall DOM tubing tied into bumpers and sliders
Unibody has been reinforced from front bumper to rear spring hangers
Front has BDS mil wrap leaf springs, rear is custom pack springs with shackle relocation brackets.
Rock Sliders, custom front and rear bumpers made from 3/16 wall box tube
Dana 60 KINGPIN front axle with 4.10 gears and locked (out of a 78 F250 snowfighter)
Dual piston calipers, rotors, pads, and hoses are all new
High Steer arms, and crossover steering made from 1.5" .25" wall DOM with heims
Dana 60 full float rear with 4.10 gears and locked (trac loc) (have extra stock shafts to go with it)
Drum brakes, all internals are new included wheel cylinders.
36" TSL's not in the best shape but good for wheeling on 16.5” aluminum outlaw wheels
Optima Yellow Top Battery
This is not a street friendly rig. The tires would need to be replaced/balanced and an alignment would be suggested if planning to run on the street. (I only used it for wheeling and thus trailered everywhere)
Has a few dents but nothing major. Body has been trimmed to accommodate tires and to keep the center of gravity low.
Future plans were to put a doubler in, i have a NP231J transfer case to go with it. Just never got around to getting it done.
Great family wheeling vehicle that will keep you out of the weather.
$5800.00
amp7876 at hotmail dot com
4.0L motor, AW4 tranny, NP242 transfer case
Vehicle has appx 110k miles, motor has appx 35K, (original overheated and cracked the head)
Exo Cage made of 1.75" .120" wall DOM tubing tied into bumpers and sliders
Unibody has been reinforced from front bumper to rear spring hangers
Front has BDS mil wrap leaf springs, rear is custom pack springs with shackle relocation brackets.
Rock Sliders, custom front and rear bumpers made from 3/16 wall box tube
Dana 60 KINGPIN front axle with 4.10 gears and locked (out of a 78 F250 snowfighter)
Dual piston calipers, rotors, pads, and hoses are all new
High Steer arms, and crossover steering made from 1.5" .25" wall DOM with heims
Dana 60 full float rear with 4.10 gears and locked (trac loc) (have extra stock shafts to go with it)
Drum brakes, all internals are new included wheel cylinders.
36" TSL's not in the best shape but good for wheeling on 16.5” aluminum outlaw wheels
Optima Yellow Top Battery
This is not a street friendly rig. The tires would need to be replaced/balanced and an alignment would be suggested if planning to run on the street. (I only used it for wheeling and thus trailered everywhere)
Has a few dents but nothing major. Body has been trimmed to accommodate tires and to keep the center of gravity low.
Future plans were to put a doubler in, i have a NP231J transfer case to go with it. Just never got around to getting it done.
Great family wheeling vehicle that will keep you out of the weather.
$5800.00
amp7876 at hotmail dot com
