- Location
- Central Maine
most likely parting this out in the spring but before it heads to bufu maine to hibernate for the winter I'll try to unload it
For sale is a 96 Jeep Cherokee Sport, floors are just about gone and will need to be replaced, front axle needs bearing and pinion seal
4.0 HO 6 cyl engine
5 sp tranny
np231 transfer case
D30 3.07
C8.25 3.07 27 spline
3.5 inch lift
Overhead console
rear sound bar
Surco roof rack
Red Exterior
Fenders have been trimmed/folded to fit 35" tires
currently have 6 31's
New stuff installed within 10k miles
Engine (20k on Jasper Rebuild)
Clutch and associated parts
2 Rear Tires
All Brakes
Rear axle rebuilt
All engine sensors, gaskets
radiator
font shocks
distributor
fuel filter
A/C system (used, needs o-rings provided) needs recharge
front wheel bearings
injector 0-rings
dynomax cat back exhaust
I have receipts for almost EVERYTHING!!!
When pics were taken there was an 8.25 in the back....still measures a true 3.5" lift
also have z28 hood vents with drip pans with matching red paint and a bunch of engine parts lying around
97+ center console and crap like that
in case your wondering it's rust colored primer on the fenders....not actual rust
asking 2500 OBO, it's going to Maine for the winter on wednesday before turkey day, interior isn't bad but if you want to buy it I'll have it professionally cleaned :guitar:
Doug
For sale is a 96 Jeep Cherokee Sport, floors are just about gone and will need to be replaced, front axle needs bearing and pinion seal
4.0 HO 6 cyl engine
5 sp tranny
np231 transfer case
D30 3.07
C8.25 3.07 27 spline
3.5 inch lift
Overhead console
rear sound bar
Surco roof rack
Red Exterior
Fenders have been trimmed/folded to fit 35" tires
currently have 6 31's
New stuff installed within 10k miles
Engine (20k on Jasper Rebuild)
Clutch and associated parts
2 Rear Tires
All Brakes
Rear axle rebuilt
All engine sensors, gaskets
radiator
font shocks
distributor
fuel filter
A/C system (used, needs o-rings provided) needs recharge
front wheel bearings
injector 0-rings
dynomax cat back exhaust
I have receipts for almost EVERYTHING!!!
When pics were taken there was an 8.25 in the back....still measures a true 3.5" lift
also have z28 hood vents with drip pans with matching red paint and a bunch of engine parts lying around
97+ center console and crap like that
in case your wondering it's rust colored primer on the fenders....not actual rust




asking 2500 OBO, it's going to Maine for the winter on wednesday before turkey day, interior isn't bad but if you want to buy it I'll have it professionally cleaned :guitar:
Doug