SCW
NAXJA Forum User
- Location
- SLC (yuck) UT
For those of you who have tried both, do you notice as significant of a change from 60-62mm as you did from 58-60mm?
Also, I using a K&N panel filter with an extra intake hose coming into the factory air-box from below the original, along with the original intake still intact (does that make sense? I added a 2 1/2" air duct to the bottom of the air box). Is this enough air for the 62mm or should I just get a cone-filter setup.
I found a source for 62mm butterfly plates for about $40 so suddenly the 62mm bore is affordable.
Thanks-
Shane Watson
Also, I using a K&N panel filter with an extra intake hose coming into the factory air-box from below the original, along with the original intake still intact (does that make sense? I added a 2 1/2" air duct to the bottom of the air box). Is this enough air for the 62mm or should I just get a cone-filter setup.
I found a source for 62mm butterfly plates for about $40 so suddenly the 62mm bore is affordable.
Thanks-
Shane Watson