rvmccarthy
NAXJA Forum User
- Location
- MS
92 Jeep NP231
4hi and 4lo have always worked just fine. Went to use 4lo the other day and the TC stayed in 4hi. When shifted into 4lo it stays in 4hi.
I shift into 4lo by stopping, putting transmission into neutral, shift TC down to 4lo.
I readjusted the shift linkage, and the TC fluid is clean and clear. 4hi works just fine, even if shifted into 4lo.
It's always been a little bit difficult to pull the level down into 4lo, but it's never made any grinding noises or anything like that.
Anyone got any ideas?
Thanks!
4hi and 4lo have always worked just fine. Went to use 4lo the other day and the TC stayed in 4hi. When shifted into 4lo it stays in 4hi.
I shift into 4lo by stopping, putting transmission into neutral, shift TC down to 4lo.
I readjusted the shift linkage, and the TC fluid is clean and clear. 4hi works just fine, even if shifted into 4lo.
It's always been a little bit difficult to pull the level down into 4lo, but it's never made any grinding noises or anything like that.
Anyone got any ideas?
Thanks!