• Welcome to the new NAXJA Forum! If your password does not work, please use "Forgot your password?" link on the log-in page. Please feel free to reach out to [email protected] if we can provide any assistance.

Recent content by guther66

  1. G

    231 TC from a TJ into an XJ?

    The input shaft on TJ 231 is a bit longer than the ones that came in the XJs. It will fit, you just need to either swap out the input shaft with one that was in the XJ or just carefully cut it.
  2. G

    Desert BBQ campout

    Looks like you had a good time.
  3. G

    What did you do to your XJ today

    I replaced some ujoints in my drivelines.
  4. G

    csf 3 core + taurus fan swap?

    I'm running two stock fans on my rig and its done just fine. I'm glad, I was bit worried :D I don't have much room after I swapped a '05 TJ motor into my '95.
  5. G

    no longer for sale

    :eek:
  6. G

    $20000 and this could be yours.

    :puke:
  7. G

    Rocker replacement with box tubes question

    Those are some nice rockers zr2toxj
  8. G

    Transfer case cable shifter

    Here's another write up. http://www.bsfab.net/?p=26
  9. G

    NP242 Application

    I know some 231 off of TJ have a longer input shaft. Could this be the same as a 231 off a ax15 on an XJ?
  10. G

    VOTE for your NAXJA National Rig of the Year!

    voted
  11. G

    Where to find D44 backing plate?

    I've got my backing plates from my D44 from when I upgraded to disk brakes. If you are interested in them.
  12. G

    taurus install

    Thanks for the reply. On the newer style XJ, is the motor more effiecient/powerful or is it just in the fan blades?
  13. G

    taurus install

    I understand the draw to the taurus fan because of the two speeds and the higher cfm ratses. Can one use two stock a/c fans? I've found that engine needs roughly 3000cfm to keep it cool, what cfm rate does a stock a/c fan have? I'm sure if varies by year, is there a website that list these...
  14. G

    Locking lugnut remover

    Or weld on a nut
  15. G

    dana 44 76 f250?

    It should, my FIL shorten a f250 D44 to waggy width. There is a bit more of the cast on the pumpkin that you have to deal with. But at full width, I would think there would be an issue. What type of arms are you planning on running?
See more
Back
Top