JWFab 1
NAXJA Forum User
- Location
- East Mesa AZ
The goal was to gain clearance and to be functional.
I had to cut the tube cause my bender wouldn't do an S bend that tight.
Then, to get rid of this.
After adding the bottom tube. I figured, it was in the way too much so it had to go.
3/16 plate was welded to the inside of the frame rail next to the gas tank so the 2" square was sandwiched in between.
Next I moved this up section and boxed it with 3/16
I also opened up the rear wheel well 5" to the rear.
I had to cut the tube cause my bender wouldn't do an S bend that tight.
Then, to get rid of this.
After adding the bottom tube. I figured, it was in the way too much so it had to go.
3/16 plate was welded to the inside of the frame rail next to the gas tank so the 2" square was sandwiched in between.
Next I moved this up section and boxed it with 3/16
I also opened up the rear wheel well 5" to the rear.
Last edited: