Working on junk almost daily

[Phil]

Re: Working on junk 12/5-7

I'm confused on this... Do you have pics of what you are talkng about??

I don't take pictures. If I do, I don't post them. Sorry.

your rig, full bodied?
ha ha

And if I'm still saying it's a bad idea...?




I'm going to delete this thread once Green Junk moves again. :roll:

 

[Bryan C.]

Re: Working on junk 12/5-7

I'm going to delete this thread once Green Junk moves again. :roll:

So this thread will never disappear then? :spin1:

 

[Phil]

I think for tonight the goal will be get the temporary lowers made up and start trimming the frame for clearance, start test flexing. Then can't get back to it until Saturday or Sunday probably, but then should be mocking up shock mounts.

 

[Harlee&Tahoe]

Re: Working on junk 12/5-7

I don't take pictures. If I do, I don't post them. Sorry.

No lie

That was Opie's contribution.

 

[XJ_ranger]

Re: Working on junk 12/5-7

That was Opie's contribution.

Here are all of the pics that I have as of when I left...

Rockey sucks -

only Phil is blurry -

note how the support rails attach to the TOP of the frame for MAXXX clearance? :roll:

upper control arm cuts -

frame plated -

LCA frame side mounts - made from 3x3x.188 box. Ramped for her pleasure -

UCA mount, dual drilled for a ~20% change in AS if further tuning is required. Made from 2x3x.120, intended to have plates on the outside to further support it -

shoved in there-

 

[XJ_ranger]

from the bottom -

the top -

all my shots are here:
http://www.therideracing.com/images/Jeep/Shop121208/index.html

 

[Ben H]

Looking good Phil, your rig is to.

 

[Letterman]

Re: Working on junk 12/5-7

note how the support rails attach to the TOP of the frame for MAXXX clearance? :roll:

I don't see a frame!

 

[NoCoastFocus]

Looking good. Any measurements from bottom of rocker before compared to now?

 

[XJ_ranger]

compare this pic:

to this pic:

(Scrappy's Parents driveway, Fresno, CA - right before the Bald Mtn Snow Run 1-13-07)

note the top of the tire and the bottom of the rock rail...

I think it was something like 10" gain?

 

[Starboard M]

It looks like it would be around the body line? Assuming there is a body of course.



This is on my list for this summer if I am home. Although I think Ill try some 1/8'' dimpled plate and some UHMW.