WJ dana 30 knuckels

[xjjeeper19]

I have a set, left and right, they are used, I was going to keep them for myself but I Have too much going on, and need them gone. I'm not sure whar all is needed to adapt them to an XJ, but I the CV style axles, and the hubs (unit bearings), however the bolt pattern is different...it's 5 on 5, not 5 on 4.5

Asking $120 obo for both, and axles/ bearings too. If needed I can ship them for free, but only to the so cal chapter, otherwise it will cost you a few extra bucks.

Justin

 

[JXPEEJ]

Trade you a AW4 for them.....How bout a NV247?

 

[JXPEEJ]

3.27 gears for that 8.8?

 

[xjjeeper19]

It came wit 3.27's don't need them. what would i do with a 247......I know I'll trade you for those new leafs you just got....

 

[JXPEEJ]

Ok, I'll go take them off. I kind a scatched them up so I'll just repaint them
for you.

 

[cal]

Just for the record here

If you wanna put those knuckles on an xj dana 30, you cant use the CV shafts or the unit bearings. The lengths/offsets will be wrong.

You'll use normal XJ shafts and 2000+ XJ/TJ unit bearings with a .250" spacer welded on (you can buy for a few bucks from JKS).

 

[xjjeeper19]

thanks cal, didn't know much about this swap. In this case if you want them please read the reply, as to what is needed.

Justin

 

[cal]

I already have a couple pairs, including a set installed on my jeep. I'm just trying to save you shipping and someone paying for parts they can't use

Use 2000+ XJ/TJ bearings and standard XJ shafts (stock or alloy) with the JKS spacer and call it done.

 

[xjjeeper19]

SOLD!