Wiper Motor?

[AirForce_XJ]

Wiper gets stops at the top of its wipe. Checked the hard to find 4.8 Amp Curcuit breaker its good as far as I can tell, gettin power everywhere. Just want advice before i start to pull the cowl off and rip the motor out.

 

[crazymoose1990]

Could be the motor or the relay check the easyest one first what about the switch does it feel loose or just not like it operates smoothly. When it gets stuck operate the swich inside see if it starts to move again. Hope it helps

 

[XJ_ranger]

does it do it on 'intermitant' as well as high / low?

The renix used a little box wired inline to control the 'intermitant'.

it can be bypassed by un-plugging it, and connecting the wires - thats how jeep did that option...

My MJ only had high / low...

HTH

 

[AirForce_XJ]

It was the motor. Switched it out today. Thanks Guys.

 

[flyingbrick]

ok so i have a renix and my all-in-one lever got wet, and my wipers only work on high now, any suggestions? just get a new lever? or is there a control box somewhere else under the dash that could be malfunctioning?

 

[Johnnie Walker]

Probably new switch