JeepCherokeeGuy99
NAXJA Forum User
- Location
- New Bern, NC
Alright guys im in a little pickle. I just installed and new ax-15 and np231 with hd sye on the jeep and I tried using a front driveshaft from a 4.0 aw4 jeep but it is not long enough by an inch or so fully extended. I'm at 6.5" lift in the front and 5.5" in the rear with a 29 spline 8.25. I took a complete measurement from the end of the ujoint cap spot on the output yoke of the np231 to the end of the ujoint cap spot on the differential yoke and that came to 35 1/2". The driveshaft I have from an aw4 jeep only extends to roughly 34" total shaft length. What are my options here?