wanted: driveshaft out of a 242/ax15 equipped XJ

[GrimmJeeper]

I took a look under the jeep today and noticed my DS yoke is pulled way out of the tcase output seal. I went from a 231 to a 242 and didn't notice till I had the tcase out today that side by side the 242 is much shorter, once my lift goes on my driveshaft will be way too short.

if anyone with 242 has gone to a hack n tap and still has their stock DS kicking around I could use it :wave1:

 

[Vanimal]

what axle?
i have one from a ax15/231/d35, which may be long enough if you had a 8.25 or d44. it's 31.5 from joint to joint.

 

[GrimmJeeper]

i'll measure mine when I get over to the garage today thanks Dan.

 

[GrimmJeeper]

going SYE (Thanks Dirtbound Offroad :wave1 so don't need this anymore.


thanks for lookin

 

[Vanimal]

no worries, did you measure it anyways? just curious what the differences are.

 

[GrimmJeeper]

no I never went over there today. I got a hellacious sun burn on sunday and i'm avoiding the sun as much as possible lol