simonsxj
NAXJA Forum User
- Location
- Daytona Beach, Florida
OK guys I want before I take the leap to get feedback on this setup:
4.0, Borg Warner T-5, Klune-V, Dana 300 (4-1), and dana 44's front and rear.
I know I have to cut the floor and move the exhaust to get the Dana 300 to fit since the output is on the pass. side but I already have it.
The T-5 is behind a 258 and that is the question I have. I can fab up the sensor hole and mounting bracket but will the T-5 hold up to the 4.0? I know it is a little more power than the 258 but less cubes, what do you guys think?
Also I am going to graft in the back end of the XJ the rear of an MJ bed and then cut the back out and have a canvas shop make a cover. Anybody had any thoughts about this before, or am I barking up the wrong tree?
Just a few things that have been biting at my head for a while.
4.0, Borg Warner T-5, Klune-V, Dana 300 (4-1), and dana 44's front and rear.
I know I have to cut the floor and move the exhaust to get the Dana 300 to fit since the output is on the pass. side but I already have it.
The T-5 is behind a 258 and that is the question I have. I can fab up the sensor hole and mounting bracket but will the T-5 hold up to the 4.0? I know it is a little more power than the 258 but less cubes, what do you guys think?
Also I am going to graft in the back end of the XJ the rear of an MJ bed and then cut the back out and have a canvas shop make a cover. Anybody had any thoughts about this before, or am I barking up the wrong tree?
Just a few things that have been biting at my head for a while.