jtkratzer
NAXJA Forum User
- Location
- Lancaster County, PA
Here is a video of the error codes using the blinking check engine light. I've never checked error codes this way and I don't think I'm getting them right.
It's a '96 4.0L 5 spd. I used the Haynes manual to run the RPMs up to a bit over 2500 and turned the AC on and off as the manual calls for.
I got 37, 25, and not sure what the last one is. Can someone tell me what the codes are?
http://youtube.com/watch?v=G7BUEza94S4
I drove it about 115 miles yesterday, mostly highway between 65 and 75 mph and everything was fine. I came to a stop light just before I got home and while sitting at the light, the CEL (check engine light) came on.
I know the oil pressure sender needs replaced. I'm going to take care of that this week. Not sure if that's a factor.
37 - Torque Converter Clutch
25 - Idle Air Control (IAC) circuit
Any help?
It's a '96 4.0L 5 spd. I used the Haynes manual to run the RPMs up to a bit over 2500 and turned the AC on and off as the manual calls for.
I got 37, 25, and not sure what the last one is. Can someone tell me what the codes are?
http://youtube.com/watch?v=G7BUEza94S4
I drove it about 115 miles yesterday, mostly highway between 65 and 75 mph and everything was fine. I came to a stop light just before I got home and while sitting at the light, the CEL (check engine light) came on.
I know the oil pressure sender needs replaced. I'm going to take care of that this week. Not sure if that's a factor.
37 - Torque Converter Clutch
25 - Idle Air Control (IAC) circuit
Any help?