xjwisconsin
NAXJA Forum User
- Location
- sturgeon bay, wisconsin
88 4.0 with BA10 and NP231
Last week I got into a little tussle with a semi and did a bunch of front end damage. Semi pulled out in front of me on an icy morning and I hit him at about 30mph. Drove away with no noticable engine damage. Fast forward to last night. I noticed some fluid on the garage floor and got underneath to take a look. After cleaning everything up underneath the heap I found a few things.
1) rear seal on the transfer case is leaking out around the shaft. I have searched and should be easy enough to remedy
2) the two front most tranny bolts on the crossmember are completly out. one was sitting on the crossmember one missing.
3) the two rear bolts appear to be working themselves out. approx 1/4" of thread showing.
4) some oil dripping from behind inspection plate on front of tranny, could be some blowby residue though...
I have not had time to search yet, but was wondering if anyone had sizes/torque for these tranny bolts. and any other ideas of intrest.
thanks
Kyle
Last week I got into a little tussle with a semi and did a bunch of front end damage. Semi pulled out in front of me on an icy morning and I hit him at about 30mph. Drove away with no noticable engine damage. Fast forward to last night. I noticed some fluid on the garage floor and got underneath to take a look. After cleaning everything up underneath the heap I found a few things.
1) rear seal on the transfer case is leaking out around the shaft. I have searched and should be easy enough to remedy
2) the two front most tranny bolts on the crossmember are completly out. one was sitting on the crossmember one missing.
3) the two rear bolts appear to be working themselves out. approx 1/4" of thread showing.
4) some oil dripping from behind inspection plate on front of tranny, could be some blowby residue though...
I have not had time to search yet, but was wondering if anyone had sizes/torque for these tranny bolts. and any other ideas of intrest.
thanks
Kyle