TIG Welding (Co. Spgs)

[Frank Z]

My plan to drill and tap my oil pan isn't going to work, the damage is too close to a corner. So before I epoxy the hole (temporary only) I thought I'd see if anyone here knew of a place where I can get it welded. The bead only needs to be about 1/4-3/8" long

 

[fullthrottle88]

I have a tig welder but need wire for it...you could borrow it if you wanted...

 

[Frank Z]

Thanks for the offer but I wouldn't have a clue about how to use it.

Time for some JBWeld.

 

[fullthrottle88]

heck yeah that is what is holding my axles under my heep....lol...there might be a little duck tape under there to just for safe measure...

 

[_dallas_]

I have a tig welder at the house if you want to bring it over. I am on the north side of Fountain.

 

[1m4j2t]

FT88
Just a question, are you sure it's a TIG and not a MIG? TIG filler is usually referred to as rod and wire spools are what go inside a MIG welder.

If it really is a TIG Frank, buy him some mild steel filler rod, and have him weld it up at his place-20 minutes tops. If that welder is near Littleton I can run the bead too...

 

[Frank Z]

Epoxyed the pan. Pics in my Penrose trip report.

Thanks for the offers though folks, much appreciated.

 

[Frank Z]

_Dallas_,
Sent you a PM.

Seems that my temporary repair was REALLY temporary.

 

[Frank Z]

Still looking for a Tig Welder.

Bueller? Bueller?

 

[_dallas_]

Sorry about that. I was out of net for a little bit.

PM replied to.