After a Tranny swap I need a new driveshaft. There arent any MJs around here in the junkyards.
I am thinking of checking in other mini trucks for a driveshaft that will fit. Especially since Rangers and S10s are all over the yards.
Also, are the joints throughout most min trucks the same size? I know im asking a lot, but looks for all the info I can get before I spend hald a day in the yards looking at trucks that dont have what I need.
My truck is a 1990 MJ, 4.0, AX-15, NP231. With a D35 rear end. The front shaft I have, my current rear shaft is about a inch too short.
If anybody has a MJ shaft that is around 43" Im intrested.
I am thinking of checking in other mini trucks for a driveshaft that will fit. Especially since Rangers and S10s are all over the yards.
Also, are the joints throughout most min trucks the same size? I know im asking a lot, but looks for all the info I can get before I spend hald a day in the yards looking at trucks that dont have what I need.
My truck is a 1990 MJ, 4.0, AX-15, NP231. With a D35 rear end. The front shaft I have, my current rear shaft is about a inch too short.
If anybody has a MJ shaft that is around 43" Im intrested.