BRIANHO13
<- Yum Chocolate
- Location
- Spring, TX
Swapped ECU's and she now lives. The bushbutton works just fine.
PUSH BUTTON START ON 98
- Thread starter BRIANHO13
- Start date
SC Rednek
NAXJA Forum User
- Location
- Winchester TN
Good to hear. Any features that you notice don't work? I've always wondered what those three extra wires were for.
Pictures of your switch setup?
Pictures of your switch setup?
BRIANHO13
<- Yum Chocolate
- Location
- Spring, TX
I have 0 creature comforts in it, so if you have no idea I will never know.
Switches right now are just hanging, I didn't mount them until I knew they worked.
Switches right now are just hanging, I didn't mount them until I knew they worked.
smalltownbird
NAXJA Forum User
- Location
- newport news,va
Sc redneck, when you wired your switches did you tap into any wires or just cut them and wire them to the switches?
SC Rednek
NAXJA Forum User
- Location
- Winchester TN
cut and wired into the switches.
smalltownbird
NAXJA Forum User
- Location
- newport news,va
Re: Re: PUSH BUTTON START ON 98
This may sound dumb, but when you wired the cut wires did you connect to the side going to the ignition or to the side going ton the rest of the wiring harness?
This may sound dumb, but when you wired the cut wires did you connect to the side going to the ignition or to the side going ton the rest of the wiring harness?
BRIANHO13
<- Yum Chocolate
- Location
- Spring, TX
Wiring harness, not sure what other wires you are refering to. You should be able to unplug the harness and cut as needed.
smalltownbird
NAXJA Forum User
- Location
- newport news,va
I was referring to the bundle of wires that are under the column and appear to run up to where the ignition switch is. Those are the ones you used, right?
BRIANHO13
<- Yum Chocolate
- Location
- Spring, TX
yup, should be able to unplug them at the switch.
