- Location
- Columbus, IN
PROJECT FLIP FLOP SUPER SWAP
- Thread starter BRIANHO13
- Start date
BRIANHO13
<- Yum Chocolate
- Location
- Spring, TX
Old picture was handy so I thought I would share.
Big 'History Repeats' Hank
I loved that jeep at that point.
RAM-ROD
NAXJA Forum User
- Location
- Libertyville IL
Nice camper...looking for one myself......
POLAR_JEEP_04
NAXJA Forum User
- Location
- Ohio
Me too. I gotta get new heads on the tow rig first since I'm burning a little oil now.
BRIANHO13
<- Yum Chocolate
- Location
- Spring, TX
Got 1st two brackets of four installed for camper tonight.
BRIANHO13
<- Yum Chocolate
- Location
- Spring, TX
4.7 liter will be going in xj......probably not b4 wf.
- Location
- Warsaw, IN
That is gonna be awesome when done. what made you decide on the 4.7?
BRIANHO13
<- Yum Chocolate
- Location
- Spring, TX
- Location
- Warsaw, IN
Sounds like your getting a Stroker for the Jeep. Awesome
POLAR_JEEP_04
NAXJA Forum User
- Location
- Ohio
No prob. Works out well for both of us.
- Location
- Michigan
that was a good deal, I'm glad you bought it cuz I really wanted it but don't have the money right now.
shortxjdoug
NAXJA Forum User
- Location
- Chattanooga tn
I have a 99 manifold and ps bracket if you need it... It's not really worth doing without it. Bore out a stock tb, runs 24s and watch the skinny pedal make it sing.
Short"will make a good deal for manifold"xjdoug
Short"will make a good deal for manifold"xjdoug
BRIANHO13
<- Yum Chocolate
- Location
- Spring, TX
RedHeep
NAXJA #1499
- Location
- Landenberg, PA
Did you see that post about flyingdan tuning on jeepstrokers? Supposedly dude can tune obd2 to make your stroker run a lot better than if you leave it stock.
BRIANHO13
<- Yum Chocolate
- Location
- Spring, TX
I will have to check it out. This will not be done by wf....gotta blow up engine that's in it first.
shortxjdoug
NAXJA Forum User
- Location
- Chattanooga tn
How is he doing the tuning? You could probably scare a little more go out of one running an adjustable map on it. They run somewhat rich at idle. As long as you make sure old sensors are replaced and reading right they run very well on stock tuning. The naxja stock class jeep runs a stock renix PCM
POLAR_JEEP_04
NAXJA Forum User
- Location
- Ohio
I have his tuning on a SCT for my niner. You don't get the full benefit unless you can data log and all that stuff plus the hand held and tunes start to add up $$$. If you can do the adjustable map and advance the timing (I can't remember now if it's the crank or cam sensor) then I'd just do that but I think those are obd1 mods.
BRIANHO13
<- Yum Chocolate
- Location
- Spring, TX
Rebuilding an 8274 warn is almost as expensive as buying a new winch. This thing better be as awesome as it's touted to be.
Welded and ground the ends on the tubes for my rockers today about 1/2 hour down....1.5 hours to finish them will be cutting it close.
Welded and ground the ends on the tubes for my rockers today about 1/2 hour down....1.5 hours to finish them will be cutting it close.
- Location
- Pekin IN/Louisville KY area
That old washer bottle has been patched a few times, then got some more holes in it. Can't believe someone wasn't smarter than that....
Looking forward to seeing what happens to this XJ in it's next life!
(subscribed)
Last edited:
shortxjdoug
NAXJA Forum User
- Location
- Chattanooga tn
It is.... It makes my m8000 look like a boat trailer winch
