PROJECT FLIP FLOP SUPER SWAP


picture.php


Old picture was handy so I thought I would share.

Big 'History Repeats' Hank
 
Nice camper...looking for one myself......
 
I have a 99 manifold and ps bracket if you need it... It's not really worth doing without it. Bore out a stock tb, runs 24s and watch the skinny pedal make it sing.

Short"will make a good deal for manifold"xjdoug
 
I have a 99 manifold and ps bracket if you need it... It's not really worth doing without it. Bore out a stock tb, runs 24s and watch the skinny pedal make it sing.

Short"will make a good deal for manifold"xjdoug


Comes w the 99 intake.....
 
Did you see that post about flyingdan tuning on jeepstrokers? Supposedly dude can tune obd2 to make your stroker run a lot better than if you leave it stock.
 
I will have to check it out. This will not be done by wf....gotta blow up engine that's in it first.
 
How is he doing the tuning? You could probably scare a little more go out of one running an adjustable map on it. They run somewhat rich at idle. As long as you make sure old sensors are replaced and reading right they run very well on stock tuning. The naxja stock class jeep runs a stock renix PCM
 
I have his tuning on a SCT for my niner. You don't get the full benefit unless you can data log and all that stuff plus the hand held and tunes start to add up $$$. If you can do the adjustable map and advance the timing (I can't remember now if it's the crank or cam sensor) then I'd just do that but I think those are obd1 mods.
 
Rebuilding an 8274 warn is almost as expensive as buying a new winch. This thing better be as awesome as it's touted to be.

Welded and ground the ends on the tubes for my rockers today about 1/2 hour down....1.5 hours to finish them will be cutting it close.
 
Rebuilding an 8274 warn is almost as expensive as buying a new winch. This thing better be as awesome as it's touted to be.

Welded and ground the ends on the tubes for my rockers today about 1/2 hour down....1.5 hours to finish them will be cutting it close.

It is.... It makes my m8000 look like a boat trailer winch
 
Back
Top