PROJECT FLIP FLOP SUPER SWAP

[kmanxj5050]

^^^^ what he said

 

[XJ&CHZ4ME]

They are just there to hang his truck nuts off of

 

[BRIANHO13]

Are those recovery rings welded to the gas tank skid?

Yes they were like that when I picked up the xj, new bumper has a hitch built in.

 

[BRIANHO13]

Bumper is done and I used a PC of angle to tie bumper to skid (and to cover up free advertising) I Telly like the way it turned out.

I need to put a bunch of weight in the rear to make it settle a little

 

[BRIANHO13]

Would have gotten more done but neighbor came over w his truck, he has a clunk and couldn't find it.

Rear drive shaft had two bolts holding it in. Front axle ujoint had 1/8" of play in it. I have NEVER seen one this loose.

 

[DoWorkXJ]

Nice! It's coming together!

 

[lesslimited]

I need to put a bunch of weight in the rear to make it settle a little

Tyler and Sean?

 

[seanR]

Re: Re: PROJECT FLIP FLOP SUPER SWAP

Tyler and Sean?

Hardy Har Har....

 

[POLAR_JEEP_04]

Hahaha!

 

[XJ&CHZ4ME]

Hey, we resemble that remark!

 

[BRIANHO13]

Rails are done and new head unit and speakers are in.

 

[ExTankerGuy]

Those d-rings will make a lot of noise smacking the skid every time you hit a decent sized bump!

 

[BRIANHO13]

Those d-rings will make a lot of noise smacking the skid every time you hit a decent sized bump!

I already cut them off

 

[seanR]

Re: Re: PROJECT FLIP FLOP SUPER SWAP

They are just there to hang his truck nuts off of

I already cut them off

Somehow this made me LOL.

 

[BRIANHO13]

Made room for "new" washer bottle w autozone filter and tube( $35) and from the chart on the box it's good for 15hp in an accura integra so it should give my 4.0 about 80 hp.

Used my second favorite tool to hold the water bottle in place, I couldn't fit the roll of duct tape in there.

And as long as I keep the water crossings under 3.5' I should be good....


Trying to figure out why the pass side front blinkers aren't working, any ideas(I checked the bulbs)

 

[87manche]

check the sockets for ground.

 

[RedHeep]

Get some scotchbrite in the sockets and clean them out.

 

[BRIANHO13]

I'm guessing it's the ground as none of the blinkers are working pass front I will check it tomorrow, thanks for the idea nate

 

[vt98xj]

The harness for the passenger side lights goes from the driver side to the passenger just behind the grill. I think there is a connector on the driver side somewhere.

 

[XJ&CHZ4ME]

Did you check the blinker fluid?

Cheese "trying to cover all bases" Man