Pro comp leafs

[POLAR_JEEP_04]

i did some searching and found next to nothing. I just ordered a pair of Pro Comp 3.5" leaf springs are these good springs does anyone else run them how do they settle any spring wrap??? thanks in advance, jason

 

[boise49ers]

Pro Comp or RE

I just done the same thread about 2 weeks ago I didn't get many positives. I ended up spending $335 and getting RE from E-bay at JeepinJoes. The REs ride sweet. I got a lot more lift then I expected and I'm dropping them down to the 1.5" hole in my shackles tomorrow instead of the 2.5" hole. I have a 6 degree shim too so I'm probably sitting at about 7" in the rear. No vibrations until 70, but I don't like it that high. The lower the better on the crap I do. I get tippy pretty often. The Pro-comp will probably be OK though if it is a full leaf pack. I'd think any way. What will be your total lift you are trying to acheive ? I think the ProComp has a built in shim too.
Good luck !

 

[Racer-X]

I am running the Pro Comp 3" full leaf packs and coil springs and I am very happy. I load it down with a small trailer and camping gear almost every weekend and I have no problems with sag. Yes it does have the shim built in and it worked well with my stock shaft. I cant say anything bad about the springs or leafs, but the Pro Comp shocks are junk.

 

[me79xj99]

i just installed my 3.5" pro comp leafs this past week, the ride is much better then the saggin add-a-leafs and 2" blocks i took out. left the lift shackles with them. not sure it was actually the full 3.5" lift but the xj weighs a bit more now too since it went into the shop with bumpers,winch,frame stiffeners,rock rails,rock krawlers long arms(heavy!!), and other little stuff. the springs seem very nice for the $$