XJSlater
NAXJA Forum User
- Location
- Ellensburg, WA
I don't know if any of you are affiliated with Performance Exhaust in Pacific, (if so you might take offense) but I went down there to get some 2.5" pipe bent and installed yesterday.
For the past couple weeks I had been getting rattles from my stock pipe (just figured the back clamp had loosened) so long story short after they were done installing the pipe he told me that the weld had broken off between the cat and muffler so thats where the rattles had come from. He said that it looked like it had a terrible weld job done on it. Well little did he know (or apparently couldn't remember) I had been down there maybe 3 months ago to get a Flowmaster 40 put on, which the same kid welded up. Once he found out about his mistake he tried to cover it up saying i probably dropped on it, causing it to break and told me my cat was bent, I checked it and its not.
Needless to say I won't be returning there again (unless my weld breaks) and definitely would urge others to shun away.
Sorry just needed to vent a little.
-Adam
For the past couple weeks I had been getting rattles from my stock pipe (just figured the back clamp had loosened) so long story short after they were done installing the pipe he told me that the weld had broken off between the cat and muffler so thats where the rattles had come from. He said that it looked like it had a terrible weld job done on it. Well little did he know (or apparently couldn't remember) I had been down there maybe 3 months ago to get a Flowmaster 40 put on, which the same kid welded up. Once he found out about his mistake he tried to cover it up saying i probably dropped on it, causing it to break and told me my cat was bent, I checked it and its not.
Needless to say I won't be returning there again (unless my weld breaks) and definitely would urge others to shun away.
Sorry just needed to vent a little.
-Adam