Rusty from Cleveland
NAXJA Forum User
- Location
- Cleveland, TN
How hard is an oil pressure sending unit/sensor to replace on a 99 4.0L w/ auto. Just searched and saw where I need to do some troubleshooting 1st but the needle pegged out in startup just a few mins ago and it will not go off of 80 PSI unless I turn the engine off. Didn't look typical when it rose up either. Immediately went to 80 PSI versus the usual lag and then going up to 40-50 psi cold. No obvious indications of 80 PSI being an accurate measurement...Thanks....Good to be back on the list after a long vacation. No doubt this board is the best resource on the web for XJ...Amazing what kids can do to your leisure time.....Rusty