Need Front Bumper bracket CAD drawing

[Gary Briggs]

I need a CAD drawing for some bumper brackets I'm going to burn out of 3/8 or 1/2 plate. I could program it myself but I'm painfully slow at programming.
Does anyone have one they could email me? I would really appreciate it.

My email is [email protected]

 

[CAJJ93XJ]

just make a template and drill some holes yeah? It's pretty easy to make shift a template and cut to fit. 1/4" should be plenty big enough. I made one for the inner rail last night it took like 15 minutes. just gotta drill holes tonight

 

[Gary Briggs]

I understand how to fab the brackets that's not the point. My shop is slow right now and I have access to the burn table. I need more experience running the burn table so I can kill two birds with one stone. Like I mentioned I'm slow at programming, it's way easier to tweak an existing drawing that to start from scratch.

Building a bumper isn't hard....


I just want to play with the Cybermation Table

 

[smokinu]

you dont need anything over 1/4inch. might be able to google this. ive seen a few threads about this through some searching.

 

[Gary Briggs]

you dont need anything over 1/4inch. might be able to google this. ive seen a few threads about this through some searching.

Then what would I do with all my free 1/2" plate I just aquired.

 

[smokinu]

im not saying dont use it. its just not needed and unwanted weight.

 

[Letterman]

I had used this:

To draw this:

And;

and:

Might have been the ugliest bumper ever made!

 

[Gary Briggs]

Have you ever browsed through the fabrication section on cherokee forum? That's definitely not the ugliest front bumper ever.

 

[gunsworth]

Re: Re: Need Front Bumper bracket CAD drawing

just make a template and drill some holes yeah? It's pretty easy to make shift a template and cut to fit. 1/4" should be plenty big enough. I made one for the inner rail last night it took like 15 minutes. just gotta drill holes tonight

We have the 1/4in tie in on ours, wife pulled out in front of a stratus and wiped out its headlight, hood, fender and door. The whole front clip of our xj is now 1/2in over, the plates have about that much bend as well.

Basically if they only bent that much from a 20mph side impact, probably dont need anything more. Also had they not bent our clip would probably be further over.