My build... long arm lift, JK axle swap, stiffeners, whole 9 yards

[woowoo]

I used a synergy jk tre on the knuckle and then a synergy xj/Tj tee in the pitman. No ream required. As for the rear brakes I used stock jk soft lines to the xj block. Got the bend out of the stock lines to that nickel copper lines. Tried to replicate the stock lines as much as possible. I'll try and see if I can get you a picture

 

[woowoo]

I stretched the front as much as I could. The pumpkin/TNT truss and track bar mount might kiss a lil. We'll see

 

[MfeMorley]

Sweet thanks man and I didn't know about that synergy stiuff, I'm probably do that instead for steering. I do have a dropped pitman arm already

Sent from my SM-G900V using Tapatalk

 

[woowoo]

No problem man. I used the Ruffstuff jk tie rod too btw but any will do. It was the better deal I thought.

 

[MfeMorley]

woowoo, Is this the drag link you used?

http://www.synergymfg.com/Synergy-Jeep-TJ-LJ-XJ-ZJ-MJ-Heavy-Duty-Drag-Link-p-31089.html

then you just used a JK tie rod end in the knuckle end of it?

 

[woowoo]

Yes sir that is correct.

 

[MfeMorley]

Thank you! I'll likely order that one as well then!

Sent from my SM-G900V using Tapatalk