Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Welcome to the new NAXJA Forum!
If your password does not work, please use "Forgot your password?" link on the log-in page.
Please feel free to reach out to [email protected] if we can provide any assistance.
So, I bought an Aussie for my D44. One problem though. My crossshaft will not clear the ring gear. If I pull the carrier out and take off the ring gear, I am afraid im going to have major issues and need my rear setup again. By the way, Im running 4.88's.
Pulling the carrier is not a problem, you will not mess up the settings on the gearing. Just make sure you remember how you took it apart, ie make sure you put the bearing caps on the way they came off, and bolt the ring gear back on the same way it come off.
I had to do the same thing with my dana 30 with 3.55 gearing.
couple things to point out. if the gears were setup properly then it will be a fight to get the carrier out without a case spreader, after that it will be a bigger fight to get it back it corectly. all dana axles are stamped on the caps and the cover surface. just look for a letter of the alphabet that looks hand stamped. they use the same letter on both sides, but on one side its straight up and down and on the other cap is turmed on its side. its pretty obvious.
also be sure to use lock tight on both the ring gear bolts and the bearing cap bolts. torque the ring gear bolts to 55 lbft in a star pattern. the bearing caps get 60 lbft of torque.
good luck.