Locked HP 30, with 4.10s

[bajatink]

I have a high pinion Dana 30 front axle from my '98 Cherokee. It has 4.10:1 gears, an Aussie Locker, lower control arm skids, and driver side tie rod flip.

It also has newer ball joints on the passenger side(driver side is still good) and brand new upper control arm bushings. The sway bar mount on the drivers side has been removed to accommodate the tie rod flip.

I am going to 4.88s and found a front that already had the gears that I needed, that is the only reason this one is for sale.

I am asking $500.00 obo as is, but would consider selling it without the locker as long as I sell the axle first.

e-mail me j_s_tink at yahoo dot com, or you can call or text- six one eight-806-96oh oh

Thanks,
Jeremy

 

[VAhasnoWAVES]

unit bearings and shafts included?
how is the pinion bearing?
where are you located?

do you already have a housing for your 4.88s to be installed into?

 

[bajatink]

Yes, shafts and bearings are included. Pinion bearing is fine. This was in my jeep until a couple weeks ago. I have the 4.88s in and need to part with this to fund gears for the rear. I am in Alton, il. 62002.

Thanks,
Jeremy

 

[bajatink]

SOLD!!!