1993 Red XJ
NAXJA Forum User
- Location
- Flora, IL
I installed JCR frunt tie in brackets and now my steering wheel is off centered. I did unbolt the steering box. What can cause that.
Installed JCR front bumper tie in brackets
- Thread starter 1993 Red XJ
- Start date
- Location
- Houston, Tx
Unbolting the steering box can cause it 
what you need to do now is unlock the steering wheel and rotate the adjustment sleeve on the drag link to re-center the wheel.
what you need to do now is unlock the steering wheel and rotate the adjustment sleeve on the drag link to re-center the wheel.
1993 Red XJ
NAXJA Forum User
- Location
- Flora, IL
So a front end alignment will fix this. Toe in was affected.
- Location
- Houston, Tx
correct
jeep ride
NAXJA Forum User
- Location
- West Virginia 25064
incorrect toe in/out is adjusted by loosening the tie rod adjustment sleeve
- Location
- Houston, Tx
Digger87xj
NAXJA Forum User
- Location
- Buffalo Creek/Lakewood CO
Simply unbolting and rebolting the steering box should not change the alignment. Was a new spacer part of the kit? If so, simply adjust the drag link sleeve. All that changes is steering wheel center and does not affect toe.
solomon7
NAXJA Forum User
- Location
- Portland OR
Center steering wheel with draglink sleeve, then use tape measure to set toe in/out with tierod sleeve.
You want the front of the tire to be 1/8-1/4" in from the rear of front tire measurement, so If back of tire measure 58", front should be 57 3/4 to 7/8".
No need to spend 80 bucks to adjust one thing and center a wheel
Still may need minor centering of steering well after toe adjustment.
You want the front of the tire to be 1/8-1/4" in from the rear of front tire measurement, so If back of tire measure 58", front should be 57 3/4 to 7/8".
No need to spend 80 bucks to adjust one thing and center a wheel
Still may need minor centering of steering well after toe adjustment.
1993 Red XJ
NAXJA Forum User
- Location
- Flora, IL
Yes Digger new spacer was installed. Stock one is junk.
1993 Red XJ
NAXJA Forum User
- Location
- Flora, IL
Will a stock trac bar be ok on a 2" inch
Overland
NAXJA Forum User
- Location
- The Chihuahuan Desert
Can't imagine why it wouldn't be. I went for years on 3" with factory everything other than the spacers and spring clamps.
jeep ride
NAXJA Forum User
- Location
- West Virginia 25064
Center steering wheel with draglink sleeve, then use tape measure to set toe in/out with tierod sleeve.
You want the front of the tire to be 1/8-1/4" in from the rear of front tire measurement, so If back of tire measure 58", front should be 57 3/4 to 7/8".
No need to spend 80 bucks to adjust one thing and center a wheel
Still may need minor centering of steering well after toe adjustment.
What section of the tire do you measure from?
