Was doing RMS and replacing oil pump on a non modified Cherokee. In order to drop oil pan out I disco'ed just about all of front suspension except for tie rods and upper control arms.
Now I am ready to stitch everything back up but I cannot get the lower CAs to sync up with axle brackets. Since I raised the frame so high the axle swung under the frame and I am trying to figure out what combination of lifting frame and/or axle it takes to get the two to mate again...any ideas?:sad1:
Now I am ready to stitch everything back up but I cannot get the lower CAs to sync up with axle brackets. Since I raised the frame so high the axle swung under the frame and I am trying to figure out what combination of lifting frame and/or axle it takes to get the two to mate again...any ideas?:sad1: