foxwar71
NAXJA Forum User
- Location
- Foxboro, MA
this is an idea i came up with for a tranny/TC skid based off the stock a stock crossmember. the two main crosses and the two side bars that span them would be either 1/4 or 3/16. on the two span bars, is 1/8 angle iron. the section covering the tranny would be removeable for serviceablitiy. the two half circles are tubin to cover the TC and cat. the middle would bolt into the original crossmember holes and the front two would be tapped or something. i was wonderin what all ur opinions on this setup would be. thnaks