Today I removed my fuel rail to change the O-Ring seals on the injectors because of ari bubbling and fuel leaking out of a few of them.
Before I removed the fuel rail I was able to get the jeep started. It ran fine but was leaking the fuel from the leaky seals.
I have another cherokee that I have removed the fuel rail many times on, and i know what im doing in that respect.
So, i got the o-rings replaced, injectors in the rail and seated the rail into position. I bolted down the 4 bolts, reconnected the injector wires, and then reattached the throttle cable bracket, and everything was good to go.
I went to start the cherokee a and nothing, it sound like its turning over fine, i checked and it is getting fuel. So i removed all the spark plugs and cleaned them. All 6 were wet.
So i put the spark plugs back in and it still wont start. So i took one spark plug out and tried turning over the motor to see if the plug was getting spark, and well its not.
Im not sure what may have happened. The car started RIGHT UP before I removed the fuel rail, but now it wont start and the spark plugs are not getting spark.
Anyone have any advice, could I have pinched a wire on the intake side of the motor. I checked to make sure all the plug wires were connected to the dis. cap and the coil pack wire is tight.
I just dont get it, starts one min then not the next. HELPPPP!!!!
Before I removed the fuel rail I was able to get the jeep started. It ran fine but was leaking the fuel from the leaky seals.
I have another cherokee that I have removed the fuel rail many times on, and i know what im doing in that respect.
So, i got the o-rings replaced, injectors in the rail and seated the rail into position. I bolted down the 4 bolts, reconnected the injector wires, and then reattached the throttle cable bracket, and everything was good to go.
I went to start the cherokee a and nothing, it sound like its turning over fine, i checked and it is getting fuel. So i removed all the spark plugs and cleaned them. All 6 were wet.
So i put the spark plugs back in and it still wont start. So i took one spark plug out and tried turning over the motor to see if the plug was getting spark, and well its not.
Im not sure what may have happened. The car started RIGHT UP before I removed the fuel rail, but now it wont start and the spark plugs are not getting spark.
Anyone have any advice, could I have pinched a wire on the intake side of the motor. I checked to make sure all the plug wires were connected to the dis. cap and the coil pack wire is tight.
I just dont get it, starts one min then not the next. HELPPPP!!!!