I just picked up a Putco 230004HW harness to use with my SilverStar sealed beams on my standard 88XJ. I got only hi or low beams, not quite sure which, so I need to electrically probe all the connections some more. I read that some H4 harnesses can be used with sealed beams. Also read its important to determine if I have a "switched-ground" or "switched-power" headlight circuit. If the Putco harness I have is wired for "switched-power", it's easy to switch the low beam wiring with the high beam wiring. Apparently a diode in the 88XJ headlight (switched-ground)circuit requires switching wires in the harness. I'm a little confused. Anyone use the 230004HW harness, as is, with sealed beams and not H4 bulbs? Or was it necessary to switch wires as stated above? Apparently, though a 6054 sealed beam pin layout is the same as the H4 pin layout, the hi/low wiring can be different? I'd appreciate any help.
Best regards,
CJR
Best regards,
CJR