snail
NAXJA Forum User
- Location
- North Jersey
Went to bolt in the rear driveshaft (a front DS from a 2000) and the U-joint at the axle yoke is too small I believe. The rear axle is an XJ D44 but apparently it was under vehicle (had to relocate perches), so the yoke could have been swapped. Question is, is this yoke for a 1330 U-joint? Will a 1330 fit in the front DS? Or do I have to swap in a different yoke
You can see that there is a decent amount of space to the U-bolt. The bottom cap is down all the way. There's not suppose to be that much space right?
You can see that there is a decent amount of space to the U-bolt. The bottom cap is down all the way. There's not suppose to be that much space right?