FS: Weld-on Steel Sliders

[the_midwesterner]

So i picked these up from Dirtbound Offroad about 6ish months ago and I believe these were cut off one of their XJs.

I never got around to install them so they just sat in the garage. I was told that these were made out .188 and they have some decent heft to them. I never actually tried to install them, so I haven't cared much to check.

Rectangle section is made out of 1"x2" and the round tube is 1.25". As mentioned, I was told these were made out of .188.

I paid $120 for them and that is what I am looking to get back. I am also willing to deliver or meet up within a reasonable distance from the south bay.

Onto the pics:

When the rectangle tube is flat, the tube kick outs are angled upward:

and here is the reason as to why i didn't install these on my jeep:

 

[DesertRatRon]

I want to do the same thing to mine but these are nice wish you were closer.

 

[itscheesey]

Where in the LBC. I'm located in Lakewood and would gladly take them off your hands per further inspection.

 

[karstic]

Where in the LBC. I'm located in Lakewood and would gladly take them off your hands per further inspection.

One post and you're already RED

/SLOWCLAP

 

[the_midwesterner]

I want to do the same thing to mine but these are nice wish you were closer.

I highly recommend it. I cut up all the way to the pillars, so it was a bit intimidating since I also had to chop off the bottom of my doors. If you only cut out the rockers though, this would be cake!!

Where in the LBC. I'm located in Lakewood and would gladly take them off your hands per further inspection.

PM replied

One post and you're already RED

/SLOWCLAP

Not sure what this means...

 

[DesertRatRon]

Yea im a little reluctant because of the cutting but i want to do 2x6 rocker replacement with mini boat sliders

 

[the_midwesterner]

These are back up for sale. The original guy interested hasn't replied to my text messages.

 

[the_midwesterner]

These are sold. Original buyer contacted me again.